Motorola Solutions PMLN8305 Manuel D'installation Et D'utilisation page 18

MN007820A01-AC
Chapter 2 : Installation Procedures
11.81 in) away from the connection point. It is not a good practice to connect the leads to the
battery pillars. Use the closest battery connection provided. The Vehicular Cradle Kit can be
damaged if there is a malfunction in the vehicle electrical system.
b Connect the blue lead to the ignition switch. Verify that the voltage is high with ignition on,
during cranking and while vehicle is running. When ignition is off, the voltage is low.
6 Connect the RF cable into the FME cable connector. Refer to the following image and
Kit Installation on page
NOTE: Applicable to PMLN8306, PMLN8308, and PMLN8310 for Vehicular Cradle RF.
Figure 8: PMLN8306, PMLN8308 and PMLN8310 Vehicular Cradle RF Connection
1
2.3
Antenna Kit Installation
Use only a Motorola Solutions approved roof antenna and refer to the antenna installation instruction
provided in the antenna kit.
Avoid visual or physical obstruction, route the antenna cable down inside the door moulding and
beneath the carpets and seats. Allow sufficient slack at the connector end of the cable to reach the
cradle FME connector.
Position the antenna in such a way to maintain a separation distance of at least 1ft (30 cm) between
the antenna connected to the car kit and the body of any user, or nearby person, to assure compliance
with regulations on RF exposure.
18
18.
1
Connect to FME cable connector
Antenna