Publicité
Å
ı
CLUTCH
ASSEMBLY AND INSTALLATION
Primary clutch
1. Install:
Washer 1
Nut (primary clutch) 2
NOTE:
Tighten the nut while holding the magneto
rotor with the sheave holder 3.
Sheave holder:
YS-1880-A/90890-01701
Clutch
1. Install:
Lock washer 1
Nut (clutch boss) 2
NOTE:
Use the clutch holding tool 3 to hold the clutch
boss.
Clutch holding tool:
YM-91042/90890-04086
Å For USA and CDN
ı Except for USA and CDN
2. Bend:
Lock washer tab
Clutch release adjustment
1. Adjust:
Clutch release
Adjustment steps:
Loosen the locknut 1.
Turn in the adjuster 2 until it is lightly
seated.
Turn out by 1/8 turn.
Tighten the locknut.
Locknut:
8 Nm (0.8 m • kg, 5.8 ft • lb)
4 - 32
ENG
50 Nm (5.0 m · kg, 36 ft · lb)
New
70 Nm (7.0 m · kg, 50 ft · lb)
Publicité
