Publicité
SPARK ARRESTER CLEANING (For USA)
a
2
1
6. Install:
7. Install:
8. Install:
SPARK ARRESTER CLEANING (For USA)
WARNING
Be sure the exhaust pipe and muffler are
cool before cleaning the spark arrester.
Do not start the engine when cleaning the
exhaust system.
1. Remove:
2. Remove:
3
3. Clean:
4. Install:
3 - 10
INSP
ADJ
Tappet cover (intake side) 1
18 Nm (1.8 m · kg, 13 ft · lb)
O-ring 2
New
Tappet cover (exhaust side)
18 Nm (1.8 m · kg, 13 ft · lb)
O-ring
New
Spark plug
13 Nm (1.3 m · kg, 9.4 ft · lb)
Timing plug
7 Nm (0.7 m · kg, 5.1 ft · lb)
Crankshaft end cover
7 Nm (0.7 m · kg, 5.1 ft · lb)
Air filter case
Air scoop (right)
Bolt (tailpipe) 1
Tailpipe 2
Pull the tailpipe out of the muffler.
Spark arrester
Use a wire brush to remove any carbon
deposits from the spark arrester portion
of the muffler body 3 inner surface.
Tap the tailpipe lightly and remove the
carbon deposits from the outside por-
tion a of the tailpipe.
Tailpipe
Insert the tailpipe into the muffler and
align the bolt hole.
Bolt (tailpipe)
7 Nm (0.7 m · kg, 5.1 ft · lb)
Publicité
