Peel Counter Function; Stand By; Cleaning - Zummo Z40 Nature Manuel D'utilisation

6.5. PEEL COUNTER FUNCTION

The machine has an automatic system for warning when the peel collection container is full. If
you want to activate this function, please proceed as follows:
 Turn off the machine's power switch.
 With the machine off, press SELECT, and continue pressing while turning the power
switch back on. Keep pressing for four seconds until you see the containers/chutes
appear on the display panel alongside a three-digit figure.
 Once this screen appears you need to enter the number of peels the machine needs to
produce before the alarm goes off. By pressing SELECT intermittently, the number of
peels will continue to increase. If, on the other hand, you press SELECT continuously for
more than two seconds, the number will start reducing.
 Once the number of peels has been selected, press STOP and that quantity will be held
in the machine's memory.
 Once the machine reaches the desired quantity it will stop and the two containers /chutes
on the display panel will blink. To continue juicing, the peel deposit must be emptied and
then the ON button pressed in order to reset the counter.
TO DEACTIVATE THE PEEL COUNTER.
Repeat the previous operation and set the counter to zero.

6.6. STAND BY

The machine has a stand-by power-saving system which is activated automatically after 5
minutes. When the machine is on Stand-By, the display light goes out and all the icons except
the one for the machine are disabled.
To exit this situation, press any of the three buttons on the plate.
To deactivate the Stand By, repeat the 7.2. section process by entering the code 8024.
To activate, repeat the process by entering the code 8023.

6.7. CLEANING

The machine squeezing area and parts must be cleaned daily.

If the machine is in operation, stop it always using the Programmer button Stop. Never
attempt to stop the machine using the main switch. Failure to follow this recommendation will
cause the machine to stop in a position that impedes cleaning; possibly leading to breakage
of parts due to poor handling.

Disconnect the machine turning the power switch off (Fig. 11). Then the digital display will
turn off (Fig. 12).

Remove one of the side panels, activating the locking system and gently pulling the back
section upwards (Fig. 13).

Remove the cover by dismantling it from the remaining side section (Fig. 14) and clean it with
a damp cloth moistened in a neutral soapy solution (IMPORTANT! NEVER use abrasive
products which might scratch it).

Remove the remaining side section as before.
31