Miller Spectrum ICE-27T Torch Mode D'emploi page 24

6-3. Wrapper Removal
Tools Needed:
Torx 25
OM-225 216 Page 20
.
A complete Parts List is available at www.MillerWelds.com
2
! Turn
disconnect input power plug
from
working on unit.
! Significant DC voltage can
remain on capacitors after unit
is Off. Wait until all front panel
LEDs are off before removing
wrapper.
! Check
1
according to Section 6-4 after
removing wrapper.
1 Wrapper
2 Torx Screws (Fine Thread)
Remove Torx screws and slide
wrapper off.
off power, and
receptacle before
DC bus voltage
Ref. 804 505-A