Grizzly MTS 30 AC Traduction De La Notice D'utilisation Originale page 98

GB
Fitting the Two-Part Tube
(Picture 3)
1. Remove the protective transport cap
(29) from the bottom shaft tube (13).
2. Loosen the tube fixing screw (12) on
the top shaft tube (10).
3. Plug the two shaft tubes (10 + 13) into
each other so the safety button (30)
clicks into the notch provided for it in
the top shaft tube.
4. Retighten the tube fixing screws (12).
pic. 3
29
13
Ensure that the bottom shaft tube
is sitting firmly and safely before
starting the equipment.
5. Dismantling:
Loosen the tube fixing screw (12).
Press the safety button (30) and pull the
tubes apart
Fitting the Handle (Picture 4)
1. Loosen the 2 Allen screws (31) on the
top shaft tube (10) and take off the
handle holder (32).
2. Place the multifunction handle (11) in
the handle slot on the top shaft tube
(10) and fix it using the handle holder
and the 2 screws.
3. Push the accelerator handle (51) onto
the end of the pipe and screw in place
with screw (52) and nut (53).
98
10
12
30
4. Fix the accelerator cable (8) using the
enclosed cable ties (27).
Ensure that the accelerator cable
(8) is not twisted or kinked.
51
53
52
31
32
8
Installing/Removing the Metal
Cutting Blade
Wear protective gloves when han-
dling the metal cutting blade.
Dismantling the reel capsule is
described in the section on "Install-
ing/Removing the Reel Capsule".
Installing the protective cover / metal
cutting blade (picture 5a):
pic. 5a
15
pic. 4
10
11
34
19