Publicité
Les langues disponibles
Les langues disponibles
GB
Risk of injury.
Never use metallic threads or
saw blades. The use of such non-
original parts can cause personal
injury and irreparable damage
to the equipment and will result
in immediate invalidation of the
guarantee.
Cleaning the Equipment
•
Clean the cutting device and protective
cover of grass and earth after each
cutting procedure.
•
The equipment is to be neither sprayed
with water nor placed in water.
•
Do not use detergents or solvents.
These could cause irreparable damage
to the equipment.
Changing the Reel (Picture 11)
1. Switch off the engine.
2. Place the equipment on the ground and
ensure that no fuel leaks and that the
equipment is safely supported.
3. Unscrew the hand nut (43) clockwise
by hand.
4. Extract the thread reel (17) from the
spool capsule (16).
pic. 11
104
5. To install the new reel, thread both
thread ends through the eyes (44) in the
reel capsule. Press the reel into the reel
capsule. Ensure that the springs are sit-
ting correctly here (45).
6. Screw on the hand nut (43) anticlock-
wise
7. Trim the thread cord to approx. 13 cm
in order to strain the engine less in the
start and warm-up phase.
Cleaning the Air Filter
(Picture 12)
Never operate the equipment
without the air filter otherwise
dust and dirt enter the engine
and result in damage to the ma-
chine. Keep the air filter clean.
1. Switch off the engine.
2. Undo the screw (46) on the filter hous-
ing (47) and take off the air filter cover
(5).
3. Remove the air filter (48) from the filter
housing (47).
4. Clean the filter with soap and water
and allow it to dry in the air
Never use petrol!
5. Reinstall the filter in reverse order.
pic. 12
43
46
17
48
45
16
44
19
.
5
47
Publicité
