Abicor Binzel ABIPLAS CUT 200 W Mode D'emploi page 28

3 Product description
Type of cooling
Max. supply temperature
Min. flow rate
Inlet pressure
Coolant conductance
Cooling unit power
Tab. 4 Torch cooling information
Type of wear parts
40–70 A
70–90 A
90–120 A
120–160 A
160–200 A
Tab. 5 Selection of plasma nozzle
1Special wear parts are for ignition-critical power sources and labelled with an 'X'.
Standard values for cutting capacity
The specifications on the cutting capacity are standard values only as they are also greatly
affected by the following factors:
• Type and quality of the material
• Compressed air pressure and impurities
• Temperature of the workpiece to be cut
• Desired cutting quality
• Condition of the electrode and the cutting nozzle
• Distance and position of the cutting torch from/in relation to the workpiece
• Power source characteristics
• Cutting speed
Max. material thickness
Low alloy steel
Stainless steel
Aluminium
Tab. 6
Standard values for cutting capacity
1Special wear parts are for ignition-critical power sources and labelled with an 'X'.
EN - 6
Standard
1.2 mm
1.4 mm
1.6 mm
1.8 mm
2.0 mm
Standard
60–70 mm at 200 A
55–65 mm at 200 A
40–45 mm at 200 A
®
ABIPLAS CUT 200 W/MT
Liquid
45°C
0.9 l/min
Min. 2.5 bar, max. 4 bar
Max. ≤ 30 µS/cm
Min. 800 W
Special
1.2 mm
1.4 mm
1.6 mm
1.8 mm
2.0 mm
Special
50–60 mm at 160 A
40–50 mm at 160 A
35–40 mm at 160 A
BAL.0120 • 2021-08-20
1
1