Grille - KitchenAid KDRP407 Guide D'utilisation Et D'entretien

(on some models)
5
6
1. Grille Grate
2. Wave Tray
3. Wave Plate
The grille module consists of a cast-iron grate, a wave tray, a
wave plate, a burner assembly, a front spill guard and a drip tray.
It is used to grill foods. Refer to the "Grille Chart" for cook times
and settings.
When using the grille, follow the guidelines below.
Do not leave the grille unattended while cooking.
Do not use aluminum foil, charcoal or wood chips.
Trim excess fat to reduce spattering. Slit the remaining fat on
the edges to prevent curling.
Allow space between food on the grille. Crowding food will
result in uneven cooking.
Use a metal spatula or tongs to turn food.
Steaks, chops and hamburgers should be turned only once
to prevent loss of juices.
For even cooking, foods such as chicken quarters should be
turned several times.
To check for doneness of meats and poultry, use an instant
read thermometer or make a small cut in the center of the
food. This will prevent loss of juices.
REMEMBER: Before removing or replacing grille, make sure the
control knobs are turned to OFF. Allow the grille to cool
completely before handling.
To Remove:
1. Remove grille grate.
2. Remove wave tray and wave plate.
3. Remove burner assembly.
4. Remove front spill guard.
5. Remove drip tray.
6. Clean basin. See "General Cleaning" section.

Grille

4. Burner Assembly
5. Front Spill Guard
6. Drip Tray
To Replace:
1. Lift burner assembly out of basin and set aside.
2. Place drip tray on bottom of grille basin and slide the tray
forward so that it is located side to side and against the
locating feet of the rear spill guard.
1
1
2
2
3
3
4
3. Insert the front spill guard feet into the slots in the rear spill
guard. The rear flange will rest on the burner box.
1
2
4. Place burner assembly over spill guard, making sure burner's
rear flange is seated in slot.
5. Install the wave tray into the grille. The tab in the left rear
corner of the bay must fit through the slot in the left rear
corner of the wave tray.
1. Rear spill guard
2. Locating feet
3. Drip tray
1. Front spill guard
2. Feet and slots
1
1. Slot for locating tab
2. Locating tab
2
11