Panasonic EYFMH1WC Instructions D'utilisation page 90

3.3 PAIRING WITH THE CONTROLLER
Enabling Pairing
Use the Pairing key on the controller unit (EYFRW2).
Select the communication lamp of the number with no registration (lamp off) and hold the
Pairing key down to enter the pairing mode.
During 2 minutes of the pairing mode, start the pairing mode on a tool within the coverage
to automatically establish pairing.
If pairing is not established within the time, the pairing mode will end.
• After you attempt to start pairing, it may take some time until the controller enters the pairing mode.
█ To register Tool No. 4
1 Press the Pairing key on the controller 4 times to select Tool No. 4.
Communication lamp No. 4 blinks.
2 While No. 4 is selected, hold down the Pairing key on the
controller to enter the pairing mode of Tool No. 4.
In the pairing mode, Communication lamp No. 4 starts blinking rapidly.
EN
Communication lamp
Pairing key
No registration
(off)
Selected
(blinking)
- 90 -
Selected (blinking)
Pairing mode
(rapid blinking)
Continued to the next page