Publicité
Les langues disponibles
Les langues disponibles
2.2 USING THE TOOL MANAGER SOFTWARE
2.2.13 HISTORY LOG ITEM LIST
Snug Point Detection Start Angle
[Display overview]
This shows the configured parameter of the angle for starting the snug point detection.
The [Snug Point Detection Start Angle] is displayed when the configured parameter of
the [Snug Point] is [Select From Graph].
Angle Error Shut-Off
[Display overview]
This shows the configured parameter of the function for stopping the tool when the
upper-limit angle is exceeded.
No Load Speed
[Display overview]
This shows the configured parameter of the speed at no load.
Disable Reverse
[Display overview]
This shows the configured parameter of the function for disabling reverse work.
Rundown Error Detection
[Display overview]
This shows the configured parameter of the function for judging work where the tool
shut off within the set time after trigger-on to be NOK.
Retightening Prevention
[Display overview]
This shows the configured parameter of the function for disabling operation of the tool
until the set time has passed since trigger-on.
Cross Thread Reduction
[Display overview]
This shows the configured parameter of the operation option for reducing cross
threading.
Soft Start Up Shift Timing
[Display overview]
When the cross threading reduction function is set for Soft start, the set time is
displayed.
- 81 -
EN
Publicité
