To install and remove the weights
1. Install the weights.
2. Install the weight lock (A).
3. Tighten the bolts (B).
4. Remove in the opposite sequence.
To examine the propane tank and lines
CAUTION:
and lines each time the propane tank is filled
and/or connected to the product.
1. Make sure that the propane tank has no damages.
2. Connect the propane tank to the product. Refer to
connect and disconnect the propane tank on page
10 .
3. Apply a soap mixture as a spray at all lines and
connections. For soap mixture use 50% soap and
50% water.
4. If there are bubbles, there is a leakage. Do not
start the engine if there is a leakage. Speak to an
approved service agent.
18
A
B
Examine the propane tank
To fill the propane tank
CAUTION:
and lines each time the propane tank is filled
and/or connected to the product. Refer to
connect and disconnect the propane tank on
page 10 .
Do not fill the propane tank too much. The propane tank
can hold a maximum of 9 kg/20 lbs of propane. A full
propane tank must not weigh more than 21.8 kg/48 lbs.
If the propane tank is filled too much, frost shows on the
propane lines or on the regulator.
1. Stop the product. Refer to
page 12 .
2. Make sure that the propane tank valve is closed.
3. Remove the propane tank from the product.
4. Fill the propane tank with new propane or replace
the propane tank.
5. Install the filled/new propane tank to the product.
To connect and disconnect the propane
Refer to
tank on page 10 .
6. If the weather is cold, keep the product indoors
before use to warm up the propane tank. You can
also use a propane tank heat blanket to warm up the
propane tank.
To do a check of the engine oil level
CAUTION:
manual of the propane engine before you do
maintenance the product.
1. Park the product on a level surface and stop the
engine.
2. Remove the oil tank cap and dipstick.
To
3. Clean the oil from the dipstick.
4. Put the dipstick back fully into the oil tank.
Examine the propane tank
To stop the product on
Always read the service
1998 - 002 - 14.12.2023
To