Publicité
Les langues disponibles
Les langues disponibles
4. Make sure that the product is assembled correctly
and is not damaged.
5. Do a check of the control panel. Make sure there are
no faults or damages.
6. Do a check of the engine oil level. Refer to
check of the engine oil level on page 18
7. Do a check of the hydraulic oil level. Refer to
check of the hydraulic oil level on page 20
8. Make sure that only approved persons are in the
work area.
9. Put the product on the work area. Make sure that the
transportation of the product to and in the work area
is done safely and correctly. Refer to
on page 23 .
10. Install a tool. Refer to
dimension and installation position on page 10 .
Make sure that the tool has the correct angle and
pitch for the operation.
11. Make sure that the blade is sharp. If it is necessary,
replace or sharpen the blade. Refer to
the blade on page 17 and To replace the blade on
page 16 .
12. If you use a self-scoring blade, make sure that the
angles at the ends of the blade (A) are sharp.
A
To select the correct blade dimension
and installation position
WARNING:
blades are very sharp.
All available blade types can be used for their approved
materials: hardwood, ceramics, linoleum, vinyl, carpet,
adhesives and glue. Refer to
It is necessary to select correct dimension and
installation of the blade for the material to remove and
the subfloor type. Blades of different dimension can be
necessary during the same work operation.
•
Select a blade of smaller dimension in these
situations:
a) At the start of an operation.
b) Operation on materials with strong adhesive.
10
To do a
To do a
Transportation
To select the correct blade
To sharpen
A
Use protective gloves. The
Accessories on page 27 .
c) Operation on hard materials.
•
Select a blade of wider dimension in these
situations:
a) Operation on soft materials.
•
Select a thicker heavy duty blade for hard materials.
A thicker blade also has a longer life.
•
Install the blade with the bevel up for removal of
materials from concrete floors.
•
Install the blade with the bevel down for removal of
materials from wood floors and soft subfloors.
To connect and disconnect the propane
tank
CAUTION:
tank type. An incorrect propane tank can
cause damage to the product. Refer to
Technical data on page 25 .
CAUTION:
tank is in correct position. Do not use the
propane tank with the top down. Refer to the
instructions of the Operator's manual of the
propane tank.
If the propane tank is connected and the product is not
in operation, close the propane tank valve.
Use the correct propane
Make sure that the propane
1998 - 002 - 14.12.2023
Publicité
