Husqvarna BMS 280P Manuel D'utilisation page 17

1. Use the tool angle control to lift the tool holder from
the floor.
2. Loosen the screws on the tool holder.
3. Remove the blade.
4. Put the new blade into the tool holder.
5. Make sure that the blade is in the correct position.
6. Tighten the screws on the tool holder.
To install a chisel
WARNING:
blades are very sharp.
WARNING:
cannot start when you replace the blade.
1. Remove the blade. Refer to
page 16 .
2. Place the chisel (A) on the tool holder (B).
C
B
A
3. Install the washers and screws (C).
1998 - 002 - 14.12.2023
Use protective gloves. The
Make sure that the product
To replace the blade on
To sharpen the blade
WARNING:
blades are very sharp.
1. Pull the tool angle handle rearward to raise the tool
holder from the floor. Make sure that the bolts are
tightened.
2. Sharpen the blade with an angle grinder. Use a
grinding disc with a grit of 120 or finer.
WARNING:
grinding disc does not catch the edge or
corner of the blade.
a) Grind the top edge of the blade for bevel up.
b) Grind the bottom edge of the blade for bevel
down.
Use protective gloves. The
Make sure that the
17