Publicité
Les langues disponibles
Les langues disponibles
Floor type
Glued hard wood flooring
Concrete
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not
a service agent, speak to them for information about the
nearest service agent.
For more detailed information, refer to .
To do before the maintenance
•
Use personal protective equipment. Refer to
Personal protective equipment on page 7 .
•
Use approved respiratory protection. The dust from
the product is dangerous to your health.
•
Park the product on a level surface.
General product maintenance
Clean the product.
Do a check of all safety devices.
Do a check of the wear and sharpness of the blade.
Make sure that all electrical connectors are clean.
Make sure that the engine is clean.
Clean the external surfaces of the product.
1998 - 002 - 14.12.2023
Blade application
For correct removal of hardwood flooring (plank solid, plank laminated, parkay,
parquetry laminated), the flooring must be pre-sawed. This is done by using a
circular saw set at a depth of 99% of the thickness of the board, just missing the
subfloor surface. Draw chalk lines across the floor and pre-saw to blade width.
(every 152mm).
True parkay flooring scoring is not necessary. It will come up in small pieces. When
working over plywood sub-flooring, try to run machine in the same direction as the
grain in the wood. Blade in most cases bevel down. On solid wood floors like plank,
run in the same direction as the plank, not cross grain or cross plank. Removing the
front counterweights will help on all soft surfaces.
When working on concrete slab, normal blade position is bevel up for best perform-
ance, especially when cleaning adhesive. On occasion, bevel down gives better
blade life.
Maintenance
Before you do
•
Stop the engine and disconnect the propane tank to
prevent accidental start during maintenance.
•
Make sure that the product is cool before
maintenance.
•
Clean the area around the product from oil and dirt.
Remove unwanted objects.
•
Set out clear signs to give a warning to bystanders
that maintenance work is in progress.
•
Keep fire extinguishers, medical supplies and an
emergency phone near.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
Daily
Each
Week-
12
ly
month
s
X
*
X
X
*
X
12 h
after
servic-
ing
15
Publicité
