Publicité
Les langues disponibles
Les langues disponibles
15. Troubleshooting
Problem
Possible Cause
1. Saw blade gets
Fastening nut tightened insufficiently
loose after turning off
the motor
2. Motor does not start a)
b)
c)
3. Motor has wrong
a) Defective capacitor
direction of rotation
b) Wrong connected
4. Engine does not
a) Cross-section of the extension line is not
provide power,the fuse
sufficient
triggers
b) Overload by blunt saw blade
5. Burns on the cutting
a)
surface
with longitudinal
b)
cuts with cross
cuts
c)
Fastening nut tightened insufficiently
Extension cable defect
Connections on the motor or switch
defect
Wrong saw blade
Longitudinal stop not parallel
Slide carriage not parallel
Help
Tighten fastening nut, right-handed thread
a)
Check the mains fuse.
b)
See "Electrical Connection" in the operating
manual
c)
Have it checked by an electrician
a) Check by qualified electrician
b) Exchange the polarity of the wall socket by
qualified electrician
a) see Electrical connection
b) Change saw blade
a)
Insert a sharpened saw blade
b)
Insert saw blade with 20 or 28 teeth for
longitudinal cuts
c)
Exchange the longitudinal stop
31 І 48
Publicité
