Zanussi ZBB25430SA Notice D'utilisation page 27

Remove the correct
part from the hinge
cover (E). Make sure
to remove the part DX,
in the case of right
hinge, SX in opposite
case.
~50 mm
o
90
21 mm
o
90
~50 mm
21 mm
Install the part (Ha) on
the inner side of the
kitchen furniture.
www.zanussi.com
C
D
E
E
B
Attach the covers (C,
D) to the lugs and the
hinge holes.
Install the vent grille
(B).
Attach the hinge cov-
ers (E) to the hinge.
Ha
Hc
Push the part (Hc) on
the part (Ha).
G H
Connect the appliance
laterally to the kitchen
furniture sidewall:
1. Loosen the
screws of the part
(G) and move the
part (G) till the
furniture sidewall.
2. Tighten the
screws of the part
(G) again.
3. Attach the part
(H) to the part
(G).
8 mm
Hb
Ha
Open the appliance
door and the kitchen
furniture door at an
angle of 90°.
Insert the small square
(Hb) into guide (Ha).
Put together the appli-
ance door and the fur-
niture door and mark
the holes.
Ha Hb
Hc Hd
Disconnect the parts
(Ha), (Hb), (Hc) and
(Hd).
8 mm
K
Ha
Remove the brackets
and mark a distance of
8 mm from the outer
edge of the door
where the nail must be
fitted (K).
27