Zanussi ZBB25430SA Notice D'utilisation page 23

Problem
Water flows into the refrig-
erator.
Water flows on the ground. The melting water outlet does not
The temperature in the ap-
pliance is too low.
The temperature in the ap-
pliance is too high.
Replacing the lamp
Caution! Disconnect the plug from the
mains socket.
Remove the screw
from the lamp cover.
Remove the lamp
cover (refer to the il-
lustration).
Replace the used
lamp with a new lamp
of the same power
and specifically de-
signed for household
appliances (the maxi-
mum power is shown
on the lamp cover).
Install the lamp cover.
Tighten the screw to
the lamp cover.
Connect the plug to
the mains socket.
Open the door. Make
sure that the light
comes on.
www.zanussi.com
Possible cause
The water outlet is clogged.
Products prevent that water flows
into the water collector.
flow in the evaporative tray above
the compressor.
The temperature regulator is not set
correctly.
The temperature regulator is not set
correctly.
Clean the water outlet.
Make sure that products do not
touch the rear plate.
Attach the melting water outlet to the
evaporative tray.
Set a higher temperature.
Set a lower temperature.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
Solution
23