Publicité
Les langues disponibles
Les langues disponibles
DUCTED COMBUSTION AIR INTAKE KIT (FS10 - FS20)
The components of the kit allow to channel the
external air directly into the burner and are availa-
ble in the standard burner equipment.
NOTE
This kit is only suitable for connection of combus-
tion air and not suitable for direct vent application.
KIT COMPOSITION
The "ducted air intake kit" is made up of:
- one 100 mm diameter air intake.
- two metallic plates to close the front and lat-
eral gratings, (see B - C, pictures 14 - 15).
- screws and washers to fix the snorkel (no. 3
for all models).
- no. 9 screws and nuts to fix the metallic plate.
MAIN FEATURES
- Installation on the top or alternatively on the
left side of the burner, according to the
requirements.
- Easy installation in the field thanks to the pre-
sheared cover, (see picture 9).
INSTALLATION DESCRIPTION
Installation must be carried out by
qualified skilled personnel. All opera-
tions must be performed according to
ATTENTION
the instructions below.
- Remove the cover from the burner.
- Remove the pre-sheared part of the cover,
which is fixed only in three points. A tool must
be used to break the fixing points, (see picture
10).
20014622
9
GB
S10279
8
S10008
9
S10007
10
Publicité
