Set-Up; Inserting Batteries, Battery Change - Renkforce IR-1600 Notice D'emploi

10. Set-Up

When selecting the set-up location, please take into consideration the room layout such as the where-
abouts of the nearest socket, etc.
When selecting the set-up site, observe that direct sunlight, vibration, dust, heat, cold and moisture must
be avoided. There also must not be any strong transformers in the device's proximity.
Do not set up the device next to any other WIFI-/WLAN or Bluetooth devices; maintain a minimum distance
of 1 m. Otherwise, there may be interference of radio reception.
Only operate the device on a stable, horizontal surface. There must be enough air circulation to
permit dissipation of the generated heat. Therefore, only place the device on level surfaces and
not on carpets, etc. Do not cover the device.
Non-observance of this note may cause damage to the device.
Do not drill or turn any additional screws into the casing to mount the device. This damages the
device and it may become possible to touch potentially fatal mains voltage.
Make sure you position the device safely. Falling devices may pose a significant risk of acci-
dent.
Place the mains cable and all other connected cables where no one can trip over it.
Due to the diversity of surfaces and furniture paints and polishes used, it is possible that the
device's feet will leave visible residue on furniture due to chemical reaction. Pressure spots may
be caused by the weight as well.
The device therefore should not be placed on valuable furniture surfaces without any suitable
protection.

11. Inserting Batteries, Battery Change

Open the battery compartment on the rear of the IR remote control and insert two type AAA/Micro batteries
with correct polarity (observe plus/+ and minus/-). Close the battery compartment again.
If the range of the IR remote control reduces or the Internet radio no longer reacts to the control
commands of the IR remote control, replace the batteries with new ones.
37