Set-Up; Commissioning; Inserting/Replacing The Batteries - Renkforce 1416079 Mode D'emploi

8. Set-Up

Never cover the device. Ensure proper ventilation when setting up the de-
vice. Maintain a sufficient distance to other devices and walls.
When setting up the product, make sure that the connection line is not
pinched or damaged by sharp edges.
Make sure that it has a stable footing and place it on a stable underground,
since falling off of the device may injure persons.
Observe that the device feet may leave coloured prints on certain furniture
surfaces. Use protection between your furniture and the device.
• Place the device on a level and stable surface.
• Completely pull out the telescopic aerial and align it vertically.
• If reception is not satisfactory after connection and commissioning, change the
alignment of the telescopic aerial or the site of setup of the device for best reception.

9. Commissioning

a) Inserting/Replacing the Batteries
For mains-independent operation, the device can be operated with four batteries type
1.5 V Mignon (AA).
Keep batteries out of reach of children.
Always keep batteries out of the reach of children. Otherwise, there is a dan-
ger of them being swallowed by children or pets. If swallowed, consult a
doctor immediately.
Remove the batteries from the battery compartment if you are not using the
device for an extended period of time to prevent damage to the device by
leakage. Leaking or damaged batteries may cause alkali burns if they come
in contact with the skin. Therefore, use suitable protective gloves.
31