Renkforce IR-1600 Notice D'emploi page 46

• The button „BACK" (M) on the Internet radio or the button „ < " (3) of the IR remote control will display 3
submenus:
1. Submenu „Scan Setting": Setting the signal strength for the station search
After selection and starting of this submenu, you can choose whether the automatic station scan is to stop
only for strong stations or for all stations.
2. Submenu „Audio Setting"
After selection and start of this submenu, you can choose whether playback is to be in mono only or not. For
weak radio stations, playback in mono instead of stereo may improve sound quality (less noise).
3. Submenu „Main menu": Back to the main menu
This submenu returns you to the main menu of the Internet radio, see chapter 14. e).
Further information on operation:
• The front of the Internet radio has 4 buttons „P1" (D), „P2" (E), „P3" (F) and „P4" (G) and station memory
slots. Keep the respective button pressed until a confirmation appears in the display.
At the bottom of the display, „P1".... „P4" then appears for the respective station.
• The IR remote control offers 12 digit buttons (9) as station memory slots. Keep the respective button
pressed until a confirmation appears in the display.
At the bottom of the display, „P1".... „P12" is shown.
The memory slots 5 - 12 can only be programmed and called with the IR remote control, but not at
the Internet radio.
The memory slots are independent of each other for the two operating modes „Internet radio"
and „FM radio".
46