Set-Up; Commissioning; Connection Of Additional Devices - Renkforce RF-DAB-IR-1700 Notice D'emploi

8. Set-Up

When selecting the set-up or mounting location, please take into consideration the room layout such as the
whereabouts of the nearest socket, etc.
When selecting the set-up or installation site, observe that direct sunlight, vibration, dust, heat, cold and moisture must
be avoided. There also must not be any strong transformers in the device's proximity.
Do not drill or screw additional screws into the casing in order to fasten the device. It would damage the
product.
Make sure you position or install the device safely. Falling devices may pose a significant risk of accident.
Due to the diversity of furniture paints and polishes used, it is possible that the device's feet will leave
visible residue on furniture due to chemical reaction. The device therefore should not be placed on valuable
furniture surfaces without any suitable protection.
Place the device on a level, straight surface that can support the load of the device.

9. Commissioning

a) Connection of additional devices
Connecting an analogue audio amplifier
• Connect the audio input of the analogue audio amplifier to the LINE OUT connector (13).
• Connect the right input to the R connector and the left input to the L connector.
Connecting a digital audio amplifier
• Connect the audio input of the digital audio amplifier to the DIGITAL OUTPUT connector (12).
• If the digital audio amplifier has an optical input, connect it to the TOSLINK connector.
• If the digital audio amplifier has a coaxial input, connect it to the COAXIAL connector.
Connecting headphones
• You can connect headphones, if required, to connection
• Connect the headphone plug to the connector
• If the headphone plug does not fit, you can use a suitable adapter.
The headphone volume is adjusted by turning the TUNE/SELECT knob (9).
48
(2).
(2).