Cleaning The Interior - shark EVO-ONE Manuel D'utilisation

textile Parts
the textiles
The Evo-One make it easy for you to
appreciate fully the performance of your
helmet.
The parts in contact with the skin are
made in a fabric that is guaranteed to feel
pleasant, to absorb perspiration well and to
resist wear satisfactorily. We treat surfaces
to limit the risk of mould and bacteria.
Warning! Although they are selec-
ted for their quality of resistance and
satisfactory wear, all the interior padding is
subject to normal wear depending on use
and care and maintenance, the length of use
and also the degree of acidity of your perspi-
ration. If you note any wear, we
advise you to replace the interior padding
in order to keep your helmet perfectly clean
and comfortable.
Your SHARK supplier can propose you with
replacement parts and also offer you cheek
pads of different thicknesses and densities,
should the standard selection not corres-
pond to the contours of your face.
16

cleaning the interior

The interior textile parts are washable; it is
important to follow the instructions below
scrupulously to avoid damaging them:
The cheek pads and head section must be
hand washed in warm, soapy water (about
Do not use aggressive detergents
30°).
but either a product for delicate mate-
rials in low dilution or household soap.
It is essential to dry textile and foam parts
completely before using them. They must be
dried at room temperature. Never iron textile
parts. For parts with a leather appearance
or textiles attached to safety elements, use
a slightly damp sponge or cloth and house-
hold soap and rinse with clean water.
allowing too much water to come into
contact with polystyrene parts.
Warning! It is essential to ensure
that all interior parts are perfectly
dry before using the helmet. The battery
feeding the LED as its electric cable could
be damaged by the moisture of fabrics and
corrode.
avoid