shark EVO-ONE Manuel D'utilisation page 87

Masquer les pouces Voir aussi pour EVO-ONE:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Warning! Never use the strap loop to
secure your helmet to your head. In order to
be properly fastened, you must thread the strap
through the double-D-rings. Failure to properly
use the double-D-rings will cause your helmet
to become dislodged during an accident, leaving
your head completely unprotected and resulting in
severe head injury or death. Try to pull down on the
chin strap with your fingers. If the strap loosens
in any way, you have not properly tightened
DoUBle-D ring
A - Slide the long part of the chin strap through
the two D rings, positioning the comfort pad
correctly between the chin strap and your neck.
B - Then bring the end of the chin strap
back through the lower of the two D rings
c
a
the chin strap with the double-D rings.
Repeat the steps above. Never ride with the chin
strap loose, improperly fastened or improperly
positioned.
Even though the comfort padding gives you the
impression that the helmet is securely held in
place, it will come off in an accident, leaving your
head completely unprotected.
If you have any doubt concerning the fastening
system of your helmet, do not use the helmet.
Contact your dealer for assistance.
as shown in the diagram.
C - Pull the strap until you feel resistance from
the strap and it is held in place under your chin
without being too tight, so that you have no
difficulty in breathing.
D - Slide the free end of the chin strap into the
plastic strap loop on the comfort padding,
in order to prevent the strap from fluttering
in the wind.
chin straP
B
D
7

Publicité

Table des Matières
loading

Table des Matières