Textile Parts - shark EVO-ONE Manuel D'utilisation

Masquer les pouces Voir aussi pour EVO-ONE:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

textile Parts

remoVing the interior Parts
We advise you to carry out this operation
with the helmet in the Jet configuration.
- Turn your helmet over.
- Separate the two parts of the chin strap.
- Detach the back part of the headgear to
remove it from its casing (Fig. A).
- Disassemble the neck pad by releasing the
hook on one side and then the other (Fig. B).
- To complete the operation, unclip the front
of the head section, starting with one side
(Fig. C) and remove the head section.
- Unclip the two cheek pads (Fig. D) and slide
them along the chin straps to extract them.
Warning! The interior padding is
critical to maintain the correct fit of
the helmet on your head. If you have any
doubt whatsoever regarding the removal
or replacement of the interior padding,
DO NOT USE YOUR HELMET. Contact your
retailer for assistance or advice. NEVER
use your helmet with any part of the inte-
rior padding removed. The helmet will not
protect you in an accident.
Warning! The polystyrene lining and
interior padding are critical to properly
fit your helmet on your head. An improper
fit could cause your helmet to become
dislodged in an accident, leaving your head
unprotected and resulting in severe head
injury or death. If you are not sure that
you properly replaced the comfort padding,
DO NOT USE YOUR HELMET. Contact your
retailer for assistance or advise.
14
a
B
c
D

Publicité

Table des Matières
loading

Table des Matières