The First Trip - Conrad Electronic REELY SEA Hydro Formula ARR Notice D'emploi

e) The First Trip
When manoeuvring, observe that you do not have a reverse gear as in a car model, for example.
Since the boat has no centrifugal force clutch, the ship propeller turns once the motor is running. The boat
therefore starts moving immediately even at idling speed once it is placed in water. Therefore, ensure that
the remote control is working properly before a run.
Attention!
The ship propeller is very sharp-edged and may cause injury and/or property damage when handling, replacing
and in operation!
Avoid hectic steering movements. Otherwise, the model may capsize and can no longer be controlled. If the model
cannot be recovered in time, ingressing water may also cause the model to sink.
Operation is only permissible with the hull deck applied. For this, the hull deck must be sealed at the body with a few
strips of transparent tape before each run. Otherwise, splash water and water from capsizing may enter the boat and
destroy the remote control and drive parts (or the boat sinks) in spite of the seal already applied. Loss of guarantee/
warranty!
If the motor goes out (e.g. if the tank is empty), the boat can no longer be controlled, floats in the water and may be lost.
Therefore, ensure that there is always enough fuel in the tank.
Trips under detriment conditions such as strong wind and strong waves are not permissible and may cause loss of the
model.
If you notice any unusual noise or sudden rotating or model speed loss during operation, terminate operation at once
and find the reason. In most cases, seaweed or something similar will have become tangled in the ship's propeller,
which may impair or render the drive near ineffective. If operation is continued, this may destroy drive components.
Loss of guarantee/warranty!
Check the water cooling function before any voyage. For this, you may use a small hose to blow air into the water
cooling inlet (see figure 2, item 4). The air (or water in driving operation) must come out of the outlet installed at the
side in the boat's body again.
Never drive with a water cooling that is clogged or non-functional because of bent hoses.
Also observe the rudder slots (figure 2, item 5). These slots are the water inlet of the water cooling. For the water
cooling system to work, it must be free of contamination at all times. The drive components may otherwise overheat
and be damaged. Loss of guarantee/warranty!
Carefully and horizontally put the model on the water. Ensure that the rudder system as well as the ship's propeller has
no ground contact and can turn freely.
Carefully pull the throttle lever towards the handle. The model starts to drive forward. Turning the remote control
steering wheel to the left or right will cause your model to turn in the respective direction.
Driving time is approx. 15 to 18 minutes with a full tank, depending on driving style. Terminate the trip in time and return
to the shore.
After a trip, the motor and muffler must cool off to ambience temperature. Therefore, make a break of approx.
5 to 10 minutes before the next trip. The hull deck should remain disassembled for better cooling.
37