Operating The Model; Fuelling Up The Model; Inspecting The Control Functions - Conrad Electronic REELY SEA Hydro Formula ARR Notice D'emploi



9. Operating the Model

a) Fuelling Up the Model
Open the body cover.
Open the tank lid and fill the tank with a two-stroke mixture (mixing ratio 1:25). Use only high-quality bio-degradable
two-stroke oil and Super fuel (Super Plus) for the mixture.
Two-stroke mixture with „E10" fuel or a mixture with a lower oil share must not be used. Motor damage
threatens at non-observance; loss of guarantee/warranty!
The boat always must be fuelled up on land so that no fuel can enter the body of water.
b) Inspecting the Control Functions
After switching on the transmitter and the receiver, your model is ready for operation. Only the motor needs
to be started.
Attention!
The ship propeller is very sharp-edged and may cause injury and/or property damage when handling, replacing
and in operation.
Check the rudder linkage.
Operate the steering wheel for steering (figure 4,
item 1). Steering to the left must cause the rudder
(viewed from behind in driving direction) to swivel to
the left as well.
If this is not the case, you need to select the steering
servo reverse function at the transmitter (see
operating instructions of the remote control system).
If the steering wheel for the steering function at the
transmitter as well as the trimming for it are in the
neutral position, the rudder must be placed centrally.
Otherwise, the trimming at the transmitter must be
adjusted accordingly (see operating instructions of
the remote control system).
Alternatively, or if transmitter trimming is no longer sufficient, you need to readjust the linkage with the control wheel in
the neutral position and neutral trimming by loosening the screws at the steering linkage (figure 2).
„Metal/metal" screw connections must be secured against unintended loosening either with so-called stop
nuts or with a drop of thread locker varnish.
34
Figure 4