During Operation - Conrad Electronic REELY SEA Hydro Formula ARR Notice D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

c) During Operation
• Do not take any risks when operating the product! Your own safety and that of your environment is solely down to
you being responsible when dealing with the model.
• Select suitable body of water to operate your model. If in doubt, ask the person responsible for the body of water
whether operation of your combustion-engine model is permitted there.
• The selected body of water must be free of climbers (e.g. seaweed) for operation of your model. There also must be
no objects (e.g. branches) floating in the water.
• Observe currents and other detriment conditions in the selected body of water that may make operation of the model
difficult or even impossible. Danger of loss of the model!
• Improper operation may cause serious injury and property damage! Therefore, make sure that there is a sufficient
safety distance to any persons, animals or objects in operation.
• Never drive right towards any swimming persons or animals.
• Drive your model only if your ability to respond is unrestricted. The influence of tiredness, alcohol or medication can
cause incorrect responses.
• Avoid hectic steering motions during operation, since this may cause the boat to capsize. If the model is not recovered
quickly in this case, it may sink due to ingressing water and therefore be lost!
• Never point the aerial of the transmitter directly onto the model. This significantly impairs signal transmission from
the transmitter to the model.
• Both the motor and muffler get hot during operation of the model. For this reason, take a break of 5 to 10 minutes
before driving again. The drive motor and muffler must have cooled down to ambient temperature.
• Never switch off the remote control (transmitter) while the model is in use. Always stop the motor first and then switch
off the receiver system. Only then should you switch off the remote control (transmitter).
• In case of a defect or a malfunction, remove the problem before using the model again.
• Never expose your model or the remote control to direct sunlight or excessive heat for an extended period of time.
• If there is any interference in operation and the model floats on the body of water without drive/control, you (or any
other person) must not endanger yourselves to recover it.
28

Publicité

Table des Matières
loading

Produits Connexes pour Conrad Electronic REELY SEA Hydro Formula ARR

Ce manuel est également adapté pour:

51 80 14

Table des Matières