Publicité
Les langues disponibles
Les langues disponibles
2
4P
DIR/
PRESET
1
2
MODE
BAND
Press TUNER/BAND
repeatedly
to select
the
desired band.
n
When TUNER/BAND
is pressed while the power is off, the
previously tuned station will be played (Direct Play Function).
To select a band with the remote control
Press BAND repeatedly.
Press
+
or B
to select a station.
Each time the button is pressed, the frequency changes.
When a station is received, "TUNE is displayed for 2 seconds.
During FM stereo reception, "[lI@Jl]" is displayed.
When an FM stereo broadcast
contains noise
Press MODE on the remote control so that "MONO appears on
the display.
Noise is reduced, although reception is monaural.
To restore stereo reception,
press MODE so that "MONO"
disappears.
MONO
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Press POWER/O
STANDBY/ON
while pressing
+>
DIR/
PRESET during power on.
To reset the interval, repeat this procedure.
m
When the AM tuning interval is changed, all preset stations are
cleared. The preset stations have to be set again.
To search for a station quickly (Auto Search)
Keep +
or >
pressed until the frequency starts to change
rapidly. After tuning in to a station, the search stops.
To stop the Auto Search manually, press +
or -.
The Auto Search may not stop at stations with very weak
signals.
7
ENGLISH
Publicité
