Publicité
Les langues disponibles
Les langues disponibles
3
1
1,2,3,4
The unit can be turned on at a specified time every day with the
built-in timer.
Preparation
Make sure the clock is set correctly. (See page 15).
1
2
3
Fkess TIMER once to display
"0",
then press
ENTER within 6 seconds.
"'~"
is displayed and the time flashes.
G
[m
1{you press ENTER after 6 seconds, another operation may
start.
Designate
the tinner-on
time
by turning
VOLUME/
MULTI
JOG
or press
4+
or
b-,
then
press
ENTER.
10 change the timer-on time by 30 minutes, press and hold
down +
or >.
After you designate the timer-on time, one of the source names
flashes on the display.
F%ess any of the function buttons (TAPE, TUNER,
AUX, CD) or turn VOLUME/MIJLTl
JOG or press
*H
or -
to
select a source,
then press ENTER.
The duration for the timer activated period flashes.
4
5
6
Select the duration for the timer-activated
period
f
with VOLUME/MULTl
JOG or press +
or Et-
E,
then press ENTER.
$1%
The duration for the timer-activated period can be set between !~~"~~
5 and 240 minutes in 5-minute steps.
H
,,, .,,
,,!8
~,:x:ii
.,. " ,:..:
Prepare the source.
?",, , .
8
", ,?
To listen to a CD, load the disc.
,"
To listen to a tape, insert the tape into deck.
~
To listen to the radio, tune in to a station.
o
To listen to the equipment connected to VIDEO/AUX iackg
set the timer of the connected source (with an external timer)
and prepare for the play.
Press POWERK!I
STANDBY/ON
to turn the unit
off after adjusting the volume and tone.
When the timer-on time is reached, the unit turns on and
begins play with the selected source.
The volume level is automatically set to 20 when the power is
turned off with the volume level set to 2"1or more.
To check the specified time and source
Press TIMER, The timer-on time, the selected source name and
the duration for the timer-activated period flash alternately for 6
seconds.
To
cancel timer standby mode temporarily
Press TIMER repeatedly until "@" or 'LO
REC"
disappears on the
display.
To restore the timer standby mode, press TIMER once or twice
to display "@" or "0
REC".
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, carry out step 5 to prepare the
source, and adjust the volume and tone.
m
. Timer playback and timer recording will not begin unless the
power is turned off.
* Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer.
... ,..,..,,
. ","".,.," ",. ".,"".",..,,
. .." " .." "", , -.",',,,! ",% . ,, , J,,"b.
,,,'".',. !,,.,... ,,,,......,, . ... .,
,
...!..% %
i_IMER REiORDING
Timer recording is applicable for TUNER and AUX/VIDEO (with
an external timer) sources only.
FWSS
TIMER repeatedly Until "O
REG"
appears on tile display,
then press ENTER within 6 seconds.
Carry out the steps of "SETTING THE TIMER from step 2 and
insert the tape to be recorded on into deck after step 5.
If TUNER is pressed, the band cannot be selected in
step.
this
ENGLISH
16
Publicité
