Publicité
Les langues disponibles
Les langues disponibles
Set the clock during power on.
DISPLAY
SLEEP
n!
n
1
VOLUME/
MULTI JOG
14QJ
!0
.—,,.,—,,—.
.—. . .. . . . ..— \
1
2
Press DISPLAY on the remote control and press
11 within 4 seconds.
The display flashes.
Press *
or -
or turn VOLUME/MULTl
JOG
to designate
the time, then press Il.
Each time +
or >
is pressed the time changes by 1
minute. To change the time by 30 minutes, press and hold
down U
or >.
To set the clock during
power off
1 Press 1I repeatedly
until the time flashes.
2 Press
+
or -
or turn
VOLUME/MULTl
JOG to
designate
the time, then press
II.
Each time +
or >
is pressed the time changes by 1
minute. To change the time by 30 minutes, press and hold
down U
or -.
To display the current time
With power on, press DISPLAY once on the remote control. The
time is displayed for
4
seconds.
However, the time cannot be displayed during recording.
When the power is off, press DEMO/ECO repeatedly until the
display changes to clock or press II once (the time is displayed
for 4 seconds).
To switch
to the 24-hour
standard
With power on, press DISPLAY then press
within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
1
2
press <
or *
to specify the time until the
power is turned off.
The time changes between 5 and 240 minutes in 5-minute
steps.
Specified time
To check the time remaining
until the power is turned off
Press SLEEP once. The remaining
time is displayed
for 4
seconds.
To cancel the sleep timer
Press SLEEP twice so that "SLEEPoFF appears on the display.
If the clock display flashes
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase need to be reset.
The unit can be turned off automatically at a specified time.
15
ENGLISH
Publicité
