Aiwa XR-M33 Mode D'emploi page 15

6 Repeat step 5 for the rest of the tracks for side A. ,.i&:
8
I
1
F
u
12
[
MODE
00
00' 0-9,+1(1
00
000
D
FUNC1-ION
0
'~
In the programmed edit recording function, the track can be
programmed while checking the remaining time on each side of
the tape as the tracks are programmed.
The programmed edit recording will not start from a point halfway
in the tape. The tape must be recorded on from the beginning of
either side.
Use the remote control from step 2 to 7.
1
2
3
4
Ilnsert the tape into deck.
~nsertthe tape with the side to be recorded on first facing out
from the unit.
lPress
FUNCTION repeatedly until "CD" is
(displayed and load the disc.
lPress MODE four times.
"EDIT" lights up and "PRGM" flashes on the display.
PRGM
EDIT
lPress numbered buttons 0-9 to designate the
tape length.
10 to 99 minutes can be specified.
Example: When using a 60-minute tape, press 6 and O.
~) The < and ~ are also available to designate the
kIpe
length.
Maximum recording
Tape length time for side A
A track whose playing time is longer than the remaining time 1~~.
7
8
Press MODE to select side B and program the
tracks for side B.
After confirming "B on the display, repeat step 5.
Tape side B (reverse side)
Press TAPE REC/REC MUTE to start recording.
The tape is rewound to the beginning of the front side, the
lead segment is played through for 10 seconds, and recording
starts. When recording on the front (side A) ends, recording
on the back (side B) starts.
"Tostop recording
Press . Recording and CD play stop simultaneously.
To check the order of the programmed track numbers
Before recording, press MODE to select side A or B, and press
Tape side
To change the program of each side
Press MODE to select side A or B, and press to clear the
program on the selected side. Then program tracks again.
To clear the edit program
Press twice so that "EDIT" disappears on the display.
m
~ Recording is inhibited if the erasure prevention tab on either
side of the tape is broken off,
0 Track number 31 and above cannot be programmed.
Tape 'side A
(front side)
5 lPress the numbered buttons O-9 and +10 to
Iprogram a track.
Examp/e
To select the 10th track, press +1 O and O.
ENGLISH
14