Publicité
Les langues disponibles
Les langues disponibles
TAPEI
REV MODE
+,-
II
INSERTING
A TAPE
You can select a reverse mode to playback one or both sides.
Use Type I (normal) tapes for playback.
=
EJECT
mark
Press TAP13REV MODE and press
to open the cassette holder
Insert a tape with the exposed side down.
holder to close.
To select a reverse mode
Each time TAPE/REV
MODE is pressed,
changes.
Push the cassette
the reverse mode
-—=)
—(-)
1
To play one side only, select =.
To play from front side to back side once only, select =).
To play both sides repeatedly, select C=).
m
MODE on the remote control can also be used to select the
reverse mode.
Insert a tape. Then press+-
to start play.
Playback side of the tape
The tape counter indicates the
tape running length
D
: The front side is being played (forward).
<:
The back side is being played (reverse).
To stop play, press
.
To pause play, press II. To resume play, press again.
To change the playback side, press+>
DIR/PRESET in play
or pause mode.
To fast forward or rewind, press U
or *
in stop mode.
Then press W to stop the tape.
To start play when the power is off (Direct Play Function)
Press TAPE. The power is turned on and play of the inserted
tape begins.
To set the tape counter to 0000
Press
in stop mode.
The counter is also set to 0000 when the cassette holder is
opened.
About cassette tapes
To prevent accidental erasure, break off the plastic tabs
on the cassette tape after recording with a screwdriver or
other pointed tool.
&
,
~:Q<l@
Side A
Tab for side A
IL-J
To record on the tape again, cover the tab openings with
adhesive tape, etc.
120-minute or longer tapes are extremely thin and easily
deformed or damaged. They are not recommended.
Take up any slack in the tape with a pencil or similar tool
before use. Slack tape may break or jam in the mechanism.
1 I
ENGL/SH
Publicité
