Maxi-Cosi Pebble 360 Pro Mode D'emploi page 78

EN
A - Carrying handle
B - XL Sun canopy (built-in)
C - Push buttons for carrying handle
adjustment (L+R)
D - Belt hooks for lap part of belt (L+R)
E - Belt buckle with belt pad
F - Harness adjuster button
G - Storage compartment for user manual
H - Harness belt tensioner strap
I - Cover
J - Newborn inlay
K - Easy-in shoulder belts with removable belt pads
L - Stroller release buttons (L+R)
M - Height adjustable headrest
N - Headrest height adjustment handle
O - Recline handle
P - Belt hook for shoulder part of belt
Q - Mounting bars for base
SAFETY
• The car seat is developed for an intensive use of
approximately 6 years.
• Do not leave your child unattended in the car. With an
outside temperature of 20 degrees the car interior heats
up in 20 minutes to 40 degrees Celsius which causes
a risk. To prevent risk of overheating consider a Child
reminder device e.g. Maxi-Cosi e-Safety inlay cushion.
Pebble 360 Pro/Pro² car use
• The car seat can be rotated and slided in and out of
the car by installing it on the Maxi-Cosi FamilyFix 360
Pro rotative base. It helps you to get your child in and
out of the vehicle easily.
• When the car safety belt is used, make sure the car
safety belt buckle runs in a straight line and stays below
the belt hook of the car seat.
• The car safety belt must be threaded tight along all
green markings. For a proper installation, check the
I
78 Pebble 360 Pro/Pro 40-87cm / max. 13 kg
2
I
Maxi-Cosi
instruction in this manual and the sticker on the side of
the car seat.
• Only use a forward-facing seat that is fitted with a
3-point safety belt that complies with the ECE R16
standard.
• When the child restraint is installed in the maximum
rearward facing position, it may not fit in all approved
vehicles. Please check that all possible positions of the
car seat (recline positions and headrest adjustment) fit
in your car.
WARNING:
• Never close your car door with the FamilyFix 360 Pro
in slided out position.
• Install the car seat only rearward facing in the car on a
forward facing vehicle seat.
• The car seat must always be locked in the rearward
facing position when travelling. Do NOT travel when the
car seat is rotated to a lateral (loading) position or to
any other unlocked intermediate position.
Pebble 360 Pro/Pro² and your baby
• Make sure you can fit no more than one finger
between the harness and your baby (1cm). If there is
more space than 1 cm, tighten the harness belt further.
• Make sure the headrest is adjusted to the proper
height.
• Make sure that the shoulder harness belts are at the
correct height. The shoulder harness belts should be on
or just below the baby's shoulders.
• The newborn inlay included in your Pebble 360 Pro/
Pro² seat is exclusively for use with the Pebble 360
Pro/Pro² and plays an integral part in the safety of the
restraint system for your child from 40 to 60 cm. The
newborn inlay is removable and the cover can be taken
off for
washing; it is essential to place it back again where it
belongs and only use this official Maxi-Cosi Pebble 360
Pro/Pro² newborn inlay.