Abus TVVR45030 Notice D'utilisation page 126

Settings - Configuration
NTP
Note
The recorder can synchronise the time with an ex-
ternal server. Several server addresses are avail-
able on the Internet for this purpose.
Tick the "Enable NTP" box and then enter the inter-
1.
val at which the synchronisation should be made
again. Enter the IP address of the NTP server and
the NTP port.
2. Confirm the settings by pressing Apply.
Email
In the event of an alarm, the device can send a message
by e-mail. Enter the e-mail configuration here:
Parameter Setting
Enable Server Tick the box when authentication is
Authentica... made on the server of the Internet
provider
User Name E-mail account at the provider
Password Password connected to the e-mail
account
SMTP Server SMTP server address of the provider
SMTP Port Enter the SMTP port here
(Default: 25)
Enable SSL Tick the box to activate the e-mail
encryption
Sender Name of the sender
Sender´s Corresponding e-mail address for
Adresse the e-mail account
Sender´s Re- Select three possible recipients for
ceiver the e-mail
Receiver Enter the name of the recipient here
Receiver´s Enter the e-mail address of the
Adresse recipient here
Enable Attached Tick the box when camera images
Picture should also be sent with the e-mail
as photo files
Interval Select the interval between the
individual recordings (2 to 5 sec-
onds)
1. Enter the parameters of the e-mail notification.
2. Click on Test to send a test e-mail.
3. Please clarify if your settings are correct and you
have received a confirmation mail. Then click on
Apply.
Note
The device sends an e-mail to the specified re-
cipients.
If the e-mail is not received, check the settings
and correct them.
If necessary, check the spam filter of your e-mail
client.
Note
Because of the cause of compatibility please do
only use E-Mail clients where a dial-up via SMTP
is possible.
SNMP
Parameter Setting
Enable SNMP Activate the checkbox to create a
connection to SNMP software
SNMP Version Version of the SNMP system
SNMP Port Enter the SNMP port
(Default: 161)
Read Community Enter the "Key" according to the set-
tings of your SNMP software.
126