Ryobi RBS-3080 Mode D'emploi page 23

6. Adjust the support (63) so that the lateral rollers (66) are positioned about 1 mm behind the base of the teeth.
7. Tighten the screw (62).
8. Loosen the screw (65) using an Allen key.
9. Push the rollers (66) (against the sawblade).
10.Turn the wheels of the saw manually several times in a clockwise direction so that the lateral rollers can position
themselves correctly – the two lateral rollers must be in slight contact with the sawblade.
11.Put the screw back in (65).
12.Adjust the roller (67) so that it is in slight contact with the sawblade.
13.Put the screw back in (68).
14.Securely screw the table back down to the table support.
15.Screw back the guide plate to the table.
9.5 CHANGING THE RUBBER TIRES (Fig. 30)
Check the rubber tires regularly for wear. Always replace the rubber tires in pairs.
1. Remove the sawblade (See the section on "Upkeep and maintenance").
2. Use a small screwdriver to remove the rubber tires.
3. Install the new tires and put the sawblade back in.
9.6 CHANGING THE CHIP GUARD (Fig. 31)
The chip guard must be changed when the saw track is damaged.
1. Remove the chip guard (69) from the table (release it from underneath).
2. Install the new chip guard.
9.7 CIRCULAR CUTTING GUIDE (Fig. 32)
The circular cutting guide can cut cylindrical workpieces with a diameter of up to 135 mm. This device guarantees you optimal
cuts when it is used with the curve-cutting sawblade.
1. Attach the guide plate with the fastener and screw.
2. Install the compass using the locking part and retaining screw.
3. Place the circular cutting guide in the desired position.
9.8 STORING YOUR SAW
Warning!
Once your saw has stopped, put your saw away so that incompetent people cannot start it up and so that no-one
runs the risk of getting hurt.
Important!
Do not leave the machine outside without protection or in a damp place.
10. A FEW RECOMMENDATIONS
Keep the surface of the table clean – in particular, remove resin residues with an appropriate spray cleaner.
Then treat the surface of the table with a lubricant.
11. REPAIRS
Warning!
Only qualified persons are authorised to repair electrical tools. When you send a part or machine for repair, please
describe the defect encountered.
If you have to replace your connecting cable, only use the manufacturer's cable.
23
GB