Attention - Service Lines; Original Ancillaries / Accessories; Before First Use; Removing / Charging / Inserting Rechargeable Battery Pack - Parkside PABS 10.8 B2 Instructions D'utilisation Et Consignes De Sécurité

General safety advice for electrical power tools / Before first use
S ecurely support the workpiece.
A workpiece held in a clamp or vice is kept more
securely in place than one held by your hand.
POISONOUS DUSTS!
Harmful / noxious dusts generated from your
work represent a risk to the health of the person
operating the device and to anyone near the
work area.
Wear safety glasses and a dust
mask!
D o not drill any material containing
asbestos. Asbestos is a known carcinogen.
H old the electrical power tool firmly.
High reaction torques may occur momentarily
during tightening or loosening of screws.
I f the inserted tool jams, switch off the
electrical power tool immediately. Be
prepared for high reaction torques as they may
cause kickback. The inserted tool may jam if
the electrical power tool is overloaded or is
held at an angle to the workpiece.
B efore you carry out any tasks on the
device, transport or store it, make sure
that the direction of rotation switch is
in the middle position (lock). To prevent
the device from starting up unintentionally.
C hildren or persons who lack the knowledge or
experience to use the device or whose physical,
sensory or intellectual capacities are limited
must never be allowed to use the device without
supervision or instruction by a person responsi-
ble for their safety. Children must never be
allowed to play with the device.

Attention - Service lines!

Q
Take steps to ensure that
you do not hit upon any service lines
(electricity, gas, water) when working
with electrical appliances. Check, if need be
with a service line detector, before you start to cut
or bore into a surface.
40 GB
Original ancillaries /
Q
accessories
U se only the ancillaries and accessories
that are detailed in the operating
instructions. The use of ancillaries and ac-
cessories other than those recommended in the
operating instructions could lead to an in-
creased risk of personal injury for you.

Before first use

Q
Removing / charging / inserting
Q
rechargeable battery pack
Note: The battery is supplied partially charged.
Charge the rechargeable battery in the charging
station for at least one hour before first use. By doing
this the battery will operate at its highest capacity.
You can charge the Li-Ion battery at any time with-
out risk of shortening battery life. Interrupting the
charging process does not damage the battery.
1. In order to remove the rechargeable battery pack
, press the release buttons
8
rechargeable battery pack
2. Insert the rechargeable battery pack
quick-charger .
15
3. Insert the mains plug into the mains socket.
The indicator LED
13
4. The green charge indicator LED
that the charging process is complete and the
battery pack is ready for use.
8
5. Insert the rechargeable battery pack
the device.

Checking the battery status

Q
To check the battery status, press the button for
the rechargeable battery LED
diagram). The status or the remaining power
will be displayed in the rechargeable battery
LED as follows:
3
RED / ORANGE / GREEN = maximum charge /
performance
RED / ORANGE = medium charge / performance
RED = low charge – recharge battery
and take the
9
out of the device.
8
into the
8
illuminates red.
shows you
14
into
8
(refer to main
2