Télécharger Imprimer la page

SQlab 310 3.0 Mode D'emploi page 22

Publicité

Les langues disponibles

Les langues disponibles

Note
The use of the SQlab handlebar sleeve aluminum 31.8 mm to 35.0 mm reduces the durability of the handlebar which is used in
conjunction with this.
With a clamping diameter of 35.0 mm, the strength is lower than with a clamping diameter of 31.8 mm.
The use of a stem with a clamping diameter of 31.8 mm in combination with a handlebar with clamping diameter of 31.8 mm is strongly
recommended here.
This combination ensures an ideal interaction of the components in terms of function and maximum durability.
Warning
Tightening torque outside the specified range
Risk of falling due to sudden and unmediated breakage of the handlebar due to deformation or necking.
Observe the specified tightening torque of the stem clamp. in the operating instructions belonging to the stem.
Never exceed the maximum tightening torque of 8 Nm. In the event of a conflict in the specifications of the tightening torque,
please contact your specialist dealer.
Mounting the Add-on Components
Now mount the remaining components on the handlebar (e.g. speedometer, grips and inner bar ends).
In order to keep the screw tightening torque low and still avoid twisting of the components, also use assembly paste when assembling
the brake and shift levers, innerbarends (if present) and the grips.
Warning
Damage to the handlebars due to incorrect clamping or burrs
Risk of accident due to sudden and unmediated breakage of the handlebars during use.
Never mount components that are clamped in the bends of the handlebar.
Do not mount bar ends or bar ends that are mounted outside the handlebar grips or inside the brake levers.
Do not mount any components with sharp edges
Do not mount any components with a tightening torque higher than 6 Nm.
Note
Innerbarends made of plastic or carbon fiber that are mounted between the brake lever and the grip are expressly permitted. For
example, the SQlab innerbarends 410/402, 411 and 411 R Carbon. Innerbarends with a clamp made of aluminum are not allowed.
After 20-50 km and at least 1/4-yearly thereafter, check the screw tightening torque of the clamping screws on the stem to the above-
mentioned torque and retighten them if necessary. When checking, also make sure not to exceed the maximum tightening torque.

Publicité

loading

Ce manuel est également adapté pour:

302 3.0321 3.0