Télécharger Imprimer la page

SQlab 310 3.0 Mode D'emploi page 20

Publicité

Les langues disponibles

Les langues disponibles

Category 3 according to DIN EN 17406
Refers to bicycles and EPACs to which condition 1 and condition 2 apply, and which are also used on rough
paths, uneven unpaved roads, as well as difficult terrain and undeveloped paths, and for which technical skill
is required. Jumps and drops shall be less than 60 cm.
Average speed in km/h
Maximum drop/jump height
Intended use
Bike type
Category 3 according to ASTM F2043-13
Bikes/attachments in this category can be used on rough trails, rough terrain and difficult routes that require
good riding technique, in addition to the conditions of use specified in categories 1 and 2. Jumps and drops
can occur here up to a maximum height of 61 cm.
Warning
Exceeding the individual load limit of the components
Risk of falling due to breakage of the components
Adhere to the permissible system and rider weight.
Use your saddle only in the intended use category or in a lower use category (according to ASTM F2043-13/DIN EN 17406).
Make an extraordinary inspection after situations with particularly or unexpectedly large force impact, such as after a fall,
riding error or an accident.
In case of doubt, the possibly damaged component should be replaced prophylactically. In such a case, better play it safe
and ask your SQlab dealer for advice.
Note
For the protection of third parties, a component that is not immediately and obviously recognizable as defective should be clearly
marked as unusable.
Mounting
Mounting of the Handlebar
Note
When mounting a new handlebar, be sure to pay attention to the following:
Wider handlebars significantly change the steering characteristics of your bike.
The changed handlebar width can lead to higher forces acting on the stem.
Handlebars with a changed width can hit the frame and possibly damage it.
You will find the handlebar width of your handlebar in the technical data of this manual.
Warning
Incorrectly mounted components
Improperly mounted components can cause a crash.
You must read and understand the instructions and notes before you begin installation.
If you have questions about the installation of these components, contact your SQlab dealer or have the handlebars
installed by an experienced mechanic at your SQlab dealer.
irrelevant
< 60 cm
Sport & competition riding
Cross-Country & Marathon bikes

Publicité

loading

Ce manuel est également adapté pour:

302 3.0321 3.0