Kenwood kMix KMX 750 BK Instructions page 13

to fit and use your splashguard
1 Raise the mixer head until it locks.
2 Fit the bowl onto the base.
3 Push the splashguard onto the
underside of the mixer head
fully located. The hinged section should be
positioned as shown.
4 Insert required tool.
5 Lower the mixer head.
tool adjustment
K-beater, Whisk, Creaming
beater and folding tool
The tools are set to the correct height
for the bowl supplied in the factory and
should not require adjustment.
However, if you wish to adjust the tool
use a suitable 15mm spanner:
Then follow the instructions below:
1 Unplug the machine.
2 Raise the mixer head and insert the
whisk or beater.
3 Lower the mixer head. If the clearance
needs to be adjusted, raise the mixer
head and remove the tool. Ideally the
whisk, K-beater and folding tool should
be almost touching the bottom of the
bowl 8.
creaming beater
• Ideally it should be in contact with the
bowl surface so that it gently wipes the
bowl during mixing
4 Using a suitable spanner loosen the nut
sufficiently to allow adjustment of the
shaft or . To lower the tool closer
9 bo
to the bottom of the bowl, turn the shaft
anti-clockwise. To raise the tool away
from the bottom of the bowl turn the
shaft clockwise.
until
6
.
bn
• During mixing, ingredients can be added
directly to the bowl via the hinged
section of the splashguard
• You do not need to remove the
splashguard to change tools.
6 Remove the splashguard by raising the
mixer head and sliding it down.
5 Re-tighten the nut.
6 Fit the tool to the mixer and lower the
mixer head.
(Check its position see points above).
7 Repeat the above steps as necessary
until the tool is set correctly. Once this is
acheived tighten the nut securely.
• Note: Spanner shown is for
illustration purpose only.
Dough Hook
This tool is set at the factory and should
require no adjustment.
8
.
7