TechniSat DIGITRADIO 140 Manuel D'instructions page 48

Please observe the display overlays. The connection process is generally completed after a few seconds and the WLAN
connection can be used.
14.2.2.3 Manual configuration
Select [Manual settings] then [Wireless] to launch manual configuration.
>
> Now select whether you will allow automatic retrieval of the IP address, gateway etc. from your router (DHCP active) or if
you would like to enter this manually (DHCP inactive).
Please take into account that the automatic retrieval of the IP address, gateway, subnet mask only works if the DHCP
function is activated in your router.
> One by one, enter the IP address, subnet mask, gateway address, primary DNS and secondary DNS if required, using the
Arrow buttons on the remote control. Confirm every set value with the OK button.
Now enter the name (SSID) of your WLAN network using the virtual keyboard and confirm with OK.
>
> Select whether your WLAN network is Open, encrypted by WEP or by WPA/WPA2 and confirm the following item.
> Continue to use the virtual keyboard to enter your WLAN password and confirm with OK to start the connection process.
In general, the WLAN connection can be used after a few seconds.
14.2.3 Display settings
> Select [Display settings] to display the current network settings.
14.2.4 Manual setting
Manual setting of the connection parameters is described for LAN in Section 14.2.1.2 and for a wireless network (WLAN) in
Section 14.2.2.3.
48