TechniSat DIGITRADIO 140 Manuel D'instructions page 22

4 Initial set-up
After switching on the DIGITRADIO 140 for the first time, the initial set-up wizard starts.
Settings can all be changed at any time in the future.
> To launch the initial set-up wizard, use the arrow buttons on the remote control to select the [YES] field and press the
OK button.
> In the next step you can select the time format. Select the desired setting [12] or [24] and press the OK button to move
on to the next step.
> Here it is possible to select which source (DAB+, FM or the Internet) the DIGITRADIO uses to obtain and update the time
and date. Once selected, proceed to the next step to enter the time zone to ensure that the time is displayed correctly.
> Proceed to specify whether summertime or wintertime is applicable at the time of setting.
> In the next step you can specify whether the DIGITRADIO should remain connected to the Internet when on standby. This
can, for example, be useful for the multi-room or app control. Power consumption is, however, increased by using the
standby mode.
The network wizard then starts and you can set up an Internet connection. Use the OK button to select the WLAN
>
network you know and enter the password using the displayed keyboard. Then select
If the password entered is correct a connection to the network is now established. The signal bar
the display indicates whether the connection has been established. To cancel the entry, select
button. If you make a typing error you can delete the last letter entered using
While the virtual keyboard is shown on the display, you can browse using the arrows buttons and the VOL+/- buttons on
the remote control. The up/down arrow buttons move the highlight upwards and downwards, the VOL+/- buttons move
the highlight to the right and left.
If you have connected the DIGITRADIO to the network using a LAN cable, select the [CABLE] item.
>
After completing the network set-up, confirm the message that the initial set-up has been completed by pressing the OK
>
button.
22
and press the OK button.
in the status bar of
and press the OK
.