TechniSat DIGITRADIO 140 Manuel D'instructions page 30

8.2.5 Deleting a saved memory slot
> Simply save the new station in the respective channel slot as described in Section 8.2.3.
8.2.6 Signal intensity
Press the INFO button as often as required until the signal intensity is shown:
>
> The bar modulation shows the current level.
Stations with a signal intensity below the required minimum signal intensity are not transmitting a strong enough signal.
Adjust the antenna position again if required.
> Under the menu item Manual setting, you can select the reception channels individually and see their signal intensity.
You can adjust the telescopic antenna optimally for channels suffering from poor reception in the installation location.
This is how stations which have not been found during a scan up until now can be found and played. To do so, select
MENU > Manual setting and then a station frequency. The signal intensity is thereupon shown in this frequency.
By pressing the INFO button several times, different information is scrolled through, such as station type, multiplex name,
frequency, signal error rate, data bit rate, station format, date, DLS.
30
Minimum signal intensity
Signal intensity