Starting Up; Outdoor Sensor - ADE WS 1822 Mode D'emploi

Starting up

Outdoor sensor

1. Remove the battery compartment cover on the rear
side of the outdoor sensor by pressing with a little force
on the imprinted arrow. Slide the battery compartment
cover in the direction of the arrow, away from the
outdoor sensor.
2. Insert 2 batteries of the type LR6 (AA) / 1.5 V as
depicted on the bottom of the battery compartment.
Pay attention to the correct polarity of the batteries
(+/-).
3. Slide the battery compartment cover back into place
on the outdoor sensor.
48
FW Station WS 1822 3 Sprach.indb 48
‚ Proceed in the order specified below and first
insert the batteries into the outdoor sensor.
Only then can the weather station function
without flaws.
‚ Do not use rechargeable batteries, since
their voltage is too low (only 1.2 V instead of
1.5 V). This affects, among other things, the
precision of the measurements.
‚ Where possible, use alkaline rather than
zinc-carbon batteries. Alkaline batteries
last longer, especially at low outdoor
temperatures.
Weather Station with Wireless Outdoor Sensor WS 1822
21.06.2018 15:33:59