Base Station; Starting Signal Reception - ADE WS 1822 Mode D'emploi

Masquer les pouces Voir aussi pour WS 1822:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Base station

1. Push the locking tab down slightly and remove the
2. Insert 3 batteries of type LR03 (AAA)/1.5 V as depicted
3. Replace the battery compartment cover and snap it
4. Wait approx. 30 minutes. The base station requires this

Starting signal reception

When the base station is energised, all displays are shown
for a brief moment. Furthermore, the display is briefly lit up
and a beep sounds.
During wireless reception by the time signal transmitter,
the buttons are disabled (except
As soon as the signals from the time signal transmitter and
wireless outdoor sensor have been received in sufficient
strength, the respective data is permanently shown in the
display.
Weather Station with Wireless Outdoor Sensor WS 1822
FW Station WS 1822 3 Sprach.indb 49
battery compartment cover.
on the bottom of the battery compartment. Pay
attention to the correct polarity (+/-).
shut.
time to collect all weather data and to receive radio
signals from the time signal transmitter.
The device then switches to receiving-mode,
during which the number of radio waves indicates
the quality of the reception: The more radio waves
shown on the display, the better is the reception.
).
49
21.06.2018 15:33:59

Publicité

Table des Matières
loading

Table des Matières