Publicité
Les langues disponibles
Les langues disponibles
Assembly instructions
Step 4
Fix sliding rail (3) on main frame (2) with one bolt M6x15 (71) and one barrel nut M10 (28). Lock the
rail (3) in extended position with the xing lever (46) and one washer ø10 (76), even if the stabilizer of
base frame (1) is raised off the oor slightly.
Step 5
Insert batteries into the computer. Fix the computer support on main frame (2) with one bolt M8x130
(64), one washer ø8 (78), one lock washer ø8 (81) and one nut M8 (83).
Step 6
Clip the grommet (55) onto both sensor
Clip the grommet (55) onto both sensor
cable parts (54). Now press the grommet
cable parts (54). Now press the grommet
(55) into the left cover (50) as shown.
Connect sensor cable (54) to cable of
computer (52). Push excess cable
parts into the left cover (50).
Step 7
Apply a small amount of included lubricate oil to a paper towel or clean cloth. Spread a thin layer of
Apply a small amount of included lubricate oil to a paper towel or clean cloth. Spread a thin layer of
Apply a small amount of included lubricate oil to a paper towel or clean cloth. Spread a thin layer of
Apply a small amount of included lubricate oil to a paper towel or clean cloth. Spread a thin layer of
the oil evenly along the rail (3) where the rollers (34) move. Then, wipe off any excess oil.
the oil evenly along the rail (3) where the rollers (34) move. Then, wipe off any excess oil.
the oil evenly along the rail (3) where the rollers (34) move. Then, wipe off any excess oil.
25
Publicité
