Bosch 0 607 450 794 Notice Originale page 14

OBJ_BUCH-1189-003.book Page 13 Friday, December 6, 2013 12:49 PM
 Hold the pneumatic tool with a not too firm yet secure
grip, compliant with the required hand-reaction forces.
The vibrations can be intensified the firmer you hold the tool.
 When universal rotary couplings (bayonet couplings)
are being used, retaining pins are required. Use Whip-
check hose restraints to protect against failed hose
connections or the connection between hose and pneu-
matic tool.
 Never carry the pneumatic tool by the hose.
 Support the screwdriver with, for example, a reaction
bar when you are working at high torque. Work at high
torques may result in damaging reaction torques, which
can be reduced by using a support device.
 If you want to operate the pneumatic tool in a suspension
device or a clamping fixture, take care to fasten it in the
device/fixture first before connecting it to the air sup-
ply. This measure prevents accidental starting of operation.
Symbols
The following symbols could have a meaning for the use of your
pneumatic tool. Please take note of the symbols and their
meaning. The correct interpretation of the symbols will help
you to use the pneumatic tool in a better and safer manner.
Symbol Meaning
 Before installing, operating, re-
pairing, maintaining and replacing
accessories as well as prior to
working near by the pneumatic
tool, please read and observe all in-
structions. Failure to follow the fol-
lowing safety warnings and instruc-
tions may result in serious injury.
Always wear ear protection
Wear safety glasses/goggles
W Watt
Nm Newton metre
kg Kilogram
lbs Pounds
mm Millimetre
min Minutes
s Seconds
Revolutions or motions per
-1
min
minute
bar bar
psi pounds per square inch
l/s Litres per second
cfm cubic feet/minute
Bosch Power Tools
Symbol
dB
QC

UNF
G
NPT
Product Description and Specifications
While reading the operating instructions, unfold the fold-out
page with the illustration of the pneumatic tool and leave it
open.
Intended Use
The pneumatic tool is intended for driving in and loosening
screws as well as for tightening and loosening nuts within the
given dimension and power range.
Product Features
The numbering of the product features refers to the illustra-
tion of the pneumatic tool on the graphics page.
1 Rotational direction switch
2 Tube connector
3 Connection thread at air inlet
4 On/Off switch
Power output
5 Air outlet with silencer
Unit of energy
6 Tool holder
(torque)
7 Tool bit
Mass, weight 8 Clutch
9 Hose clamp
Length
10 Supply-air hose
Time period, dura-
The accessories illustrated or described are not included as stand-
tion
ard delivery.
Noise/Vibration Information
No-load speed
Measured sound values determined according to
EN ISO 15744.
Air pressure
Typically the A-weighted noise levels of the pneumatic tool
are: Sound pressure level 88 dB(A); sound power level
Air consumption
99 dB(A). Uncertainty K=3 dB.
Wear hearing protection!
Meaning
Unit of relative loud-
Decibel
ness
Quick-change chuck
Symbol for hexagon socket
Symbol for external drive
Tool holder
US fine thread
(Unified National Fine
Thread Series)
Whitworth thread
Connecting thread
National pipe thread
Right rotation
Rotational direction
Left rotation
Read all safety warnings and all instruc-
tions. Failure to follow the warnings and in-
structions may result in electric shock, fire
and/or serious injury.
3 609 929 C64 | (6.12.13)
English | 13