Makita VR001G Manuel D'instruction page 7

2. Insert a battery cartridge in place aligning its
tongue with the groove on the tool. If you can see the
red indicator as shown in the figure, it is not locked
completely.
2
Fig.5
► 1. Red indicator 2. Battery cartridge
3. Close the battery case securely.
Uninstallation
1. Open the battery case while pressing the buttons
on sides of the battery case.
2. Slide the battery cartridge off from the tool while
pressing the button on front of the battery cartridge.
2
Fig.6
► 1. Button 2. Battery cartridge
3. Close the battery case securely.
1 1
1
For cord connected power source
Optional accessory
Replace the standard equipped battery case with an
optional battery case H before installation.
Installation
1. Open the battery case while pressing the buttons
on sides of the battery case.
2. Insert a battery adapter in place aligning its tongue
with the groove on the tool. If you can see the red indi-
cator as shown in the figure, it is not locked completely.
2
Fig.7
► 1. Red indicator 2. Battery adapter
3. Open the rubber sealing grommet in the battery
case.
Make sure to squeeze the rubber sealing grommet out
of the round hole rim from inside the front cover of the
case.
1
Fig.8
► 1. Rubber sealing grommet 2. Front cover
7 ENGLISH
1
2