Makita VR001G Manuel D'instruction page 11

2. Hold the drive shaft in the tool still using the
wrench provided. Then hand thread the end fitting of the
flexible core shaft onto the solid drive shaft in the tool.
Fig.17
► 1. Drive shaft 2. End fitting 3. Flexible core shaft
3. Fasten the end fitting of the flexible core shaft up
tightly using a pair of pliers.
Fig.18
4. Hand thread the coupling of the outer casing onto
the male thread of the tool.
3
2
Fig.19
► 1. Coupling 2. Outer casing 3. Male thread
1
2
3
1
1
Fig.20
► 1. Outer casing 2. Flexible core shaft
NOTE: The coupling does not reach or fit securely
onto the male thread of the tool, when the top of the
flexible core shaft is not fit into the slot in the vibration
head. To fit them fully, pull the outer casing further
towards the tool while hand-turning the flexible core
shaft.
CAUTION:
Do not force the flexible core shaft
into the outer casing. Do not operate the tool with
the battery to fit the flexible shaft. Such actions
may cause personal injury or damage to the flexible
core shaft.
5.
Knock each of the three corners of triangular
coupling with a hammer a few times in random order to
secure assembly.
Fig.21
Uninstallation
Follow the installation steps in reverse order.
11 ENGLISH
2